mline example adds one new command to MicroStation.

• PLACE BLOCK MLINE: Place Multi-line block.

Command operation is the same as the standard "PLACE BLOCK" command. The Multi-line produced uses the active multi-line definition.

To use this application:

• Compile the application: bmake +a mline.mke
• Start MicroStation
• Load the application: keyin MDL LOAD MLINE
• Use the new command listed above

Note: If multiline compatibility is ON (SET COMPATIBLE MLINE ON), multi-lines will be saved as MicroStation 3.x (IGDS 8.8) compatible primitive elements.